Figure 45 Phone; Table 29 Phone - ZyXEL Communications Prestige 2602R Series User Manual

Prestige 2602R Series User's Guide

Figure 45 Phone

The following table describes the labels in this screen.

Table 29 Phone

LABEL
Phone Port Settings
Speaking Volume
Listening Volume
Outgoing Call use
G.168 Active
VAD Support
116
DESCRIPTION
Use this field to select the phone port that you want to configure.
Use this field to set the loudness that the Prestige uses for the speech signal
that it sends to the peer device. -1 is the quietest and 1 is the loudest.
Use this field to set the loudness that the Prestige uses for the speech signal
that it receives from the peer device and sends to your phone. -1 is the quietest
and 1 is the loudest.
SIP 1 and SIP 2 correspond to the Prestige's SIP accounts. Select whether you
want the phone(s) attached to this phone port to use SIP account 1, 2 or both
when you make a call. If you select both SIP accounts, the Prestige will first try
to use SIP account 2 and then SIP account 1 when you make a call.
You cannot call the SIP number of the SIP account that you are using to make
a call. The Prestige generates a busy tone and does not attempt to establish a
call if the SIP number you dial matches the outgoing SIP number of the phone
port you are using.
For example, if you set Phone 1 to use SIP account 1 and set Phone 2 to use
SIP account 2, then you can use Phone 1 to call to SIP account 2's SIP
number or Phone 2 to call to SIP account 1's SIP number.
Select this check box to cancel the echo caused by the sound of your voice
reverberating in the telephone receiver while you talk.
Select this check box to use Voice Activity Detection (VAD).
VAD reduces the bandwidth that a call uses by not transmitting when you are
not speaking.
Chapter 8 Voice Screens