Control panel
Turn the controls panel I, as shown in figure
Fig. 9.7, to access in an optimal manner the
components inside the boiler.
Fig. 9.7
9.4
Reassembly the external panels
Side panels
Fit the external panels E and G in the reverse
order to that described on section "Disman-
tling the external panels" to page 80.
Front panel
• Fit the front panel D, hooking it on the up-
per side.
• Push the spring towards the internal side of
the boiler and simultaneously push the front
case panel D until it is completely hold in
place (Fig. 9.8) step 1-2.
• Repeat the same operation on the opposite
side of the front panel D, (Fig. 9.8) step 3-4.
• Ensure that the front panel edge is close-
fitting to the side panels.
• Lock in place the panel D with the appropri-
ate screws A (Fig. 9.6.
MAINTENANCE
G
I
Fig. 9.8
9.5
• Turn off the d.c.w .inlet isolating valve 6 (Fig.
9.9).
3
Fig. 9.9
Emptying the d.h.w. system
Close
position
E
D
6
7
- 81 -