Fig. 9.7
9.4
Reassembly the external panels
Side panels
Fit the external panels E and G in the reverse
order to that described on section "Disman-
tling the external panels" to page 81.
Front panel
• Fit the front panel D, hooking it on the up-
per side.
• Push the spring towards the internal side of
the boiler and simultaneously push the front
case panel D until it is completely hold in
place (Fig. 9.8) step 1-2.
• Repeat the same operation on the opposite
side of the front panel D, (Fig. 9.8) step 3-4.
• Ensure that the front panel edge is close-
fitting to the side panels.
• Lock in place the panel D with the appropri-
ate screws A (Fig. 9.6.
- 82 -
MAINTENANCE
G
I
Fig. 9.8
9.5
• Turn off the d.c.w .inlet isolating valve 6 (Fig.
9.9).
3
Fig. 9.9
• Turn on the hot water taps and any drain
cocks.
Emptying the d.h.w. system
Close
position
E
D
6
7