eter, indicating entry in "parameter 03" (Fig.
7.26).
Fig. 7.26
• Use key 11 or 12 to modify the value of
parameter 03 to 00=maximum speed or
01=average speed.
• The writing P03 - SEt alternates on the dis-
play (Fig. 7.27).
Fig. 7.27
• By pressing key 14 (Fig. 7.24) confirmation
of the inserted value is obtained.
• Press keys 17 or 18 to exit without changing
the value.
• Exiting the "programming mode" is auto-
matic, after 15 minutes, or by cutting power.
7.13 Setting the pump post-circula-
tion
The pump, in heating function, is set for a
post-circulation of about one minute at the end
of each heat request.
This time can be changed by a minimum of
zero to a maximum of four minutes by acting
on programming both from the panel controls
- 70 -
COMMISSIONING
and the remote control.
• Enter in "programming mode" by pressing
keys 14 - 17 - 18 (Fig. 7.28) for 10 seconds
at the same time until the letters P01 are
displayed on the LCD display, indicating that
"parameter 01" (Fig. 7.29) has been acti-
vated.
11
12
13
Fig. 7.28
Fig. 7.29
• Scroll the various parameters using keys 17
or 18 until the letters P11 are displayed on
the LCD display, indicating that "parameter
11" (Fig. 7.30) has been activated.
Fig. 7.30
• It is possible to modify parameter 11 by
00=0s to 99=255s using keys 17 or 18
(each increase or reduction by a unit on the
14 15
19
18
17
16