Table of Contents
Advertisement
Fig. 9.4
• By pressing key 14 (Fig. 9.1) confirmation of
the inserted value is obtained.
• Press keys 17 or 18 to exit without changing
the value.
• Exiting the "programming mode" is auto-
matic, after 15 minutes, or by cutting power.
After maintenance, if the value is left on 0 the
maintenance symbols will not disappear but
instead continue to flash, as they did prior to
maintenance.
The remaining months until maintenance will
be replicated in read only in the 'info' section
under value J15.
N.B.: The flashing symbol in Fig. 9.5 is not an
error. The boiler continues to run normally but
it indicates the expiry of the maintenance pe-
riod.
Fig. 9.5
9.3
Dismantling the external panels
Front panel
• Unscrew screws A and remove the front
- 80 -
MAINTENANCE
panel D by pulling it and pushing it towards
the top so that it is freed from the top hous-
ings (Fig. 9.6).
Side panels
Loosen screws "B - F" and "C - H" in Fig. 9.6
and remove the two side panels E and G by
pulling towards the outside.
A
B
F
G
Fig. 9.6
C
E
H
D
Advertisement
Table of Contents
