Led State Page - JVC VN-H37U Instructions Manual

Internet Explorer Setting
Settings (continued)

LED State Page

This page sets the [STATUS] LED indication of the camera.
This page can be used during access using AadminB or AoperatorB.
Click [Advanced Settings] and [LED State].
Memo:
● Press the [OK] button to enable the new settings. If you press the [Cancel] button, your changes are
canceled and the current camera settings are displayed.
Status LED
A
LED State
B
Identify Unit
70
Allow to check and set the [STATUS] LED indication of the camera.
Turns the [STATUS] indicator On or Off when the camera is operating.
Enable : Continues to light when the camera is operating.
Disable : Turns the indicator Off after the camera has started.
[Set values: Enable, Disable]
If you wish to blink the [STATUS] indicator of the camera, set this option to
ABlinkB. This may occur if you wish to visually check the camera operation
when configuring the camera from the PC.
[Set values: Enable, Blink]
Memo:
● If you have set the [LED State] to ADisableB, the indicator does not light
even when you set the [Identify Unit] to ABlinkB.
* The [Set values] in bold letters are factory defaults.
A
B