JVC VN-H37U Instructions Manual page 40

Internet Explorer Setting
Settings (continued)
Storage Page (continued)
G
Constant (continued)
Sunday to Saturday
H
Alarm
Encoder
Trigger1, Interval,
Trigger2
Position Number
Day/Night (VN-H37U and
VN-H237VPU only)
Time
Pre-Trigger
Post-Trigger
40
Sets the start and end time of recording for each day of week.
[Set values: Unmask All, Mask All, Unmask Span, Mask Span]
If you have selected ASpecify the time period for invoking the actionB
or ASpecify to stop the actionB, you must set the time period.
[Set values: 00H00M-24H00M]
Sets alarm recording.
Sets an encoder for alarm recording and a JPEG frame rate.
[Set values: 1 to 5 to 30 fps]
Memo:
● You can select an Encoder No. for JPEG.
● The frame rates that can be set vary depending on the
encoding settings.
Condition 1: Sets a condition to record an alarm.
[Set values: Position, Motion detection, Day/Night,
Tampering Detection, Time]
Interval: Unavailable.
Condition 2: Unavailable.
Position Number is displayed if Trigger1 is set to APositionB.
This function executes an action if the trigger is moved to the
position entered.
[Set values: 0 to 19]
Day/Night is displayed if Trigger1 is set to ADay/NightB.
Color : Executes an action when the image changes from Black
and White to color.
Black and White: Executes an action when the image changes
from color to Black and White.
[Set values: Color, Black and White]
Memo:
● This function is valid only for models with Day and Night.
Time is displayed if Trigger1 is set to ATimeB.
This function executes an action at the time you have entered.
[Set values: 00H00M-24H00M]
Sets a trigger time before FTP recording (a recording time before
alarm input) in seconds.
[Set values: 0 to 5 to 60 sec]
Sets a trigger time after FTP recording (a recording time after
alarm input) in seconds.
[Set values: 0 to 5 to 60 sec]
* The [Set values] in bold letters are factory defaults.