JVC VN-H37U Instructions Manual page 30

Internet Explorer Setting
Settings (continued)
Encoding Page (continued)
C
Multi-Encode2 (continued)
Encoder Encoding
No.2 Display
Framesize
Framerate
Bitrate
I Frame
Interval
D
Monitor Output
30
Displays the "MPEG-4" encoding selected for Multi-Encode2.
Displays the frame size selected for Multi-Encode2.
Specify the frame rate for Multi-Encode2.
[Set values: 15 fps, 10 fps, 7.5 fps, 1 fps]
Select whether to set the control rate mode for encoding to CBR
(Constant Bit Rate) or VBR (Variable Bit Rate).
CBR : Data is encoded at a fixed bit rate regardless of the condition of
input video signals. It is easy to estimate the bit rate. Select
from the list of bit rate ranges.
VBR : The bit rate varies according to the condition of input video
signals. The picture quality is stabled but it is difficult to
estimate the bit rate. Select from the list of bit rate ranges.
[Set values: CBR, VBR]
Bit rate range
[Set values: 64 kbps, 128 kbps, 256 kbps, 348 kbps, 512 kbps,
768 kbps, 1024 kbps, 1536 kbps, 2048 kbps, 3072 kbps,
3584 kbps, 4096 kbps, 8192 kbps]
Select the I-frame interval. Encoding starts from the I-frame. Shortening
the interval stabilizes the picture quality even when there are rapid
changes in the video image; however, the picture quality for images with
little change will deteriorate. In addition, when multicast packet loss
occurs, the time interval required to restore the image is shorter.
[Set values: 15, 30]
Sets monitor output.
[Set values: ON, OFF]
Memo:
● To turn the monitor output ON, set the following in the [Single Encode]
(JPEG/MPEG-4/H.264 Baseline/H.264 High) option:
• Aspect ratio = 16:9
• Frame size = 1920x1080
• Frame rate = 5 fps or less
● If you toggled the MONITOR switch, you will need to restart the
camera.
* The [Set values] in bold letters are factory defaults.