JVC VN-H37U Instructions Manual page 42

Internet Explorer Setting
Settings (continued)
Storage Page (continued)
J
SD Card
K
Overwrite Old Image
L
Encoder
M
SD Card Recording Mode
42
Sets an SD card.
[Set values: Use, Disuse, Locked, Not Inserted]
When [Use] is selected, the selection may change to [Locked] or [Not
Inserted] depending on the status of the SD card. When [Locked] or
[Not Inserted] are selected, you cannot record to the SD card.
[Locked]: The SD card's switch is set to ALockB. Remove the SD
card and disable the ALockB in order to record to the SD card.
[Not Inserted]: The SD card is not inserted into the camera. Insert
an SD card.
Memo:
● To prevent the destruction of recorded data, be sure to set
[Disuse] before turning off the camera or removing the SD card.
● Be sure to format the SD card with the camera before using it.
Only an SD card formatted with this camera can be used.
Allows to overwrite the old image of SD card with new data.
[Set values: Valid, Invalid]
Memo:
● For [Valid], images will be overwritten in order from oldest to
newest once there is no more free space on the SD card.
Sets an encoder for recording rate.
Sets a recording mode of SD card.
To stop recording to the SD card, set the [SD Card] setting to
[Disuse], or set [Storage Mode] to [OFF]. (A Page 38)
[Set values: Continuous recording, Alarm recording,
Recording during network failure]
Continuous recording:
Continuously records to the SD card when
turned on.
Alarm recording: Records H.264 video around the time when the
specified conditions are met to the SD card.
Backup: Records to the SD card when a network
connection failure occurs.
Only the set Encoder No. will be recorded.
(Note that this is not the Encoder No. for which
the failure occurred.)
Memo:
● A [Storage Mode] is set to AOFFB, [SD Card Recording Mode]
changes to AContinuous recordingB.
* The [Set values] in bold letters are factory defaults.