JVC VN-H37U Instructions Manual page 60

Internet Explorer Setting
Settings (continued)
Multicast Page (continued)
Encoder No.1 to
No.3
A
Encoding
B
FrameSize
C
FrameRate
D
Destination
Address
E
Destination
Port
F
Start
Memo:
● If the camera power supply is turned Off during multicast streaming, the camera will restart multicast
streaming automatically after the camera is restarted.
● Settings A~F are not displayed when the encoder is set to "OFF".
60
Sets the manual streaming of Encoder No.1 to Encoder No.3.
Displays the A EncodeB being set for each encoder.(A Page 25)
[Display values: JPEG, H.264 Baseline, H.264 High, MPEG-4)]
Displays the "FrameSize" being set for each encoder. (A Page 24)
Displays the AFrameRateB being set for each encoder. (A Page 24)
You can change it if the encoding is AJPEGB.
[Set values: 1/30 to 5 to 30 fps]
Memo:
● You can change the frame rate if it is below the limit specified on the
[Basic Setting2] page or on the [Encode] page.
Sets a destination address for encoded data streaming.
Set a multicast address. If you have another device for multicast streaming,
set a different multicast address.
[Factory default: Encoder No.1: 255.0.1.1, Encoder No.2: 255.0.2.1,
Encoder No.3: 255.0.4.1]
Sets a destination port number for encoded data streaming. Enter an even
number to meet the RTP. If you have another device for multicast streaming,
you should set a different port number.
If a port number is duplicated, you cannot receive multiple number of
multicast data using a single PC.
[Factory default: Encoder No.1: 49152, Encoder No.2: 59152, Encoder
No.3: 29152]
Saves the encoder settings, and starts manual streaming. The [Stop] button
is displayed during manual streaming.
You cannot change the frame rate, destination address, and destination port
during data distribution.
Memo:
● To save the settings made to the entire page, press the [OK] button.
* The [Set values] in bold letters are factory defaults.