If Your Network Does Not Support Dhcp - Nortel IP Phone 2007 User Manual

Standard
Table 6 DHCP configuration parameters
Parameter
S1 RETRY Count
S2 IP
S2 Port
S2 ACTION
S2 RETRY COUNT
VLAN (0=No, 1=Yes)
cfg XAS
After you press the Ok soft key on the last configuration parameter, you see a
message "Locating Server".

If your network does not support DHCP

Use the following procedure if your network does not support DHCP.
Configuring parameters
1
Enter a 0 on the dialpad to indicate that DHCP is not supported.
Value
1
<valid Server IP address>
5000
1 or 7
1
0
0-No, 1-Yes
Warning: The VLAN parameter must never be selected unless the
underlying network switches are configured to filter on VLAN IDs.
Otherwise, the IP Phone 2007 can fail to work properly.
Definition
Primary retry count
Secondary server (IP Client
Manager or Multimedia PC
Client) IP address
Note: If you do not know the
secondary IP address, use
the primary IP address for
the secondary address.
Secondary server port
Note: If you do not know the
secondary port, use the
primary port.
Secondary action code
(must be configured to 1 if
using Unistim Firmware)
Secondary retry count
QoS 802.1q VLAN Tag
Service
Select No
IP Phone 2007 User Guide
133