Begin The Initialization Process; If Your Network Supports Dhcp - Nortel IP Phone 2007 User Manual

Standard
132

Begin the initialization process

To begin the initialization process, at the flashing Nortel screen, quickly press 0,
0, 7, star (*) on the dialpad.
If your network supports DHCP go to
page 132. If your network does not support DHCP go to
support DHCP" on page

If your network supports DHCP

To initialize you IP Phone 2007 if your network supports DHCP:
1
If your IP Phone 2007 network supports DHCP, enter the configuration
parameters at the prompt in the display area of your telephone as described in
Table 6 "DHCP configuration parameters" on page
Table 6 DHCP configuration parameters
Parameter
DHCP (enable)
DHCP (full or partial)
S1 IP
S1 PORT
S1 ACTION
NN42020-104 MCS 5100 Release 4.0
Tip: If you miss the flashing introduction screen, unplug and plug in
your IP Phone 2007 to reach the configuration screen where you can
press the keys.
133.
Tip: If necessary, contact your system administrator to check whether
your network supports DHCP.
Value
1
1
<valid Server IP address>
5000
1 or 7
Standard 01.04
"If your network supports DHCP" on
"If your network does not
132.
Definition
Yes
Partial
Primary server (IP Client
Manager or Multimedia PC
Client) IP address
Primary server port
Primary action code (must
be configured to 1 if using
Unistim Firmware)
March 2007