Booting The Terminal; Suspending And Resuming Operation - Symbol PDT 7500 Series Product Reference Manual

To power on the PDT 7500:
1. make sure a fully charged battery is installed in the terminal.
2. press the power key
To suspend the PDT 7500's operation, press the power key again.

Booting the Terminal

The warm boot process is similar to pressing the <Ctrl+Alt+Del> keys on a PC. To perform
a warm boot, press and hold the power key for 6 seconds, then release.
Cold booting the terminal generates a system reset, the same as a power-on boot on a
standard PC. To cold boot the terminal, hold down the Power key for 15 seconds or for the
amount of time set in Setup. See Chapter 8, Terminal Configuration: Setup for more
information on Setup.

Suspending and Resuming Operation

To suspend or resume operation, press the PWR key
also resume operation from various wakeup sources (if enabled through the application). The
wakeup sources available on the PDT 7500 are listed in Table 4-1.
Note: The default for enabling/disabling these wakeup sources depends on
how the terminal is suspended (manual suspend using the PWR key
vs. automatic suspend via timeout). An application can also control
the source of a terminal wakeup, overriding the defaults.
Source
PWR key and touch panel power area
AC adapter connect
Cradle insert/remove
Battery insert
.
Table 4-1. PDT 7500 Wakeup Sources
Manual Default
Operating the Terminal
on the PDT 7500. The terminal can
Automatic Default
(PWR key)
enabled
disabled
disabled
disabled
(timeout)
enabled
enabled
enabled
enabled
4-3