Symbol PDT 7500 Series Product Reference Manual page 95

Error
Line Stat Err
Baud too High
Image Corrupt
Wrong Area
Not Hex File
Write Error
Checksum Err
Terminal Configuration: Build and Send the Hex Image
Table 6-1. IPL Errors (Continued)
A framing error was detected in the incoming data. The
most probable cause of this is a parameter mismatch
between the terminal and the device used to transmit the
data. The baud rate on both devices must be set to the same
value, and the transmitting device must be set to 8 data bits,
no parity, and at least one stop bit.
This error could be caused by transmitting large
compressed images at a high baud rate, or by faulty flash.
This error indicates that the image received by the terminal
is corrupt. The most probable cause of this error is inserting
an IPL-enabled terminal into a cradle while the host is
transmitting an image.
This error indicates that the image being received has an
incorrect area number. This could be caused by specifically
selecting an area, and loading an image intended for
another area, or by receiving an image for an area that is
not defined in the partition map.
This error is caused by transmitting the wrong file format
to IPL. IPL can only receive Hex files supplied by Symbol,
or generated by TCM.
This error is caused by a failure of the flash device used to
hold the image. If this error is seen, then the terminal
requires maintenance.
This error is occurs when one of the critical partitions
(BIOS, Partition Map, or Setup) has been received with no
apparent errors, but the received image does not pass the
checksum check. The most probable cause of this error is a
failure of the tool used to generate the image. If this error
is displayed, then the original contents of the partition will
not have been changed as the error is detected before any
flash is updated.
Explanation
6-21