Charging The Spare Battery In The Cradle - Symbol PDT 7500 Series Product Reference Manual

A fully discharged battery requires approximately 2 hours to recharge.

Charging the Spare Battery in the Cradle

To recharge a spare battery:
1. Verify that the cradle has power.
2. Insert the battery in the spare battery compartment charging slot.
Note: Spare batteries can only be inserted and removed when the terminal is
not in the VCD 7500 cradle.
3. Check the cradle LEDs to determine the spare battery's charging status (refer to
Table 3-2).
a. If the Spare Battery Charge LED is yellow, the battery is still charging and should
not be used.
b. When the LED changes to green, the battery is fully charged. The Spare Battery
requires 4 hours to fully charge
4. To remove the battery from the charging slot, lift the battery out of the charging slot.
Condition
Battery Charging LED
Off
Steady yellow
Steady green
Flashing yellow
Communications LED
Off
On (yellow)
Table 3-2. Battery Charging LEDs
Spare battery absent, no charge power, or outside temperature
range required for charging battery.
Spare battery is charging.
Spare battery is charged.
Abnormal battery.
Terminal is not trying to communicate.
Terminal is able to send and receive data.
Cradle Setup and Operation
LED State
3-15