Symbol PDT 7500 Series Product Reference Manual page 107

After adjusting all settings on this screen, press the left arrow key on the terminal's keypad to
move to the next setup screen.
Suspend
Set the length of time (in minutes) after which the terminal will suspend if left idle. Values are
in increments of 5,and span 0-1000. The default value is 30. To change this value, press the
(+) key on the terminal's keypad to increment, or the (-) key to decrement the value. When
the correct value appears in the field, press the down arrow to move to the backlight time
field.
Backlt Time
Set the length of time (in minutes) after which the backlight turns off. Values are in increments
of 1, and span 0-60. The default value is 10. To change this value, press the (+) key on the
terminal's keypad to increment, or the (-) key to decrement the value. When the correct value
appears in the field, press the down arrow to move to the Cold Boot field.
Cold Boot
Set the time after which the terminal will perform a cold boot. Values are in increments of 1,
and span 6-63. The default value is 15. To change the value, press the (+) key on the terminal's
keypad to increment, or the (-) key to decrement the value. When the correct value appears
in the field, press the down arrow to move to the Enable field.
Enable
Set the maximum allowable clockspeed. Values for this field are 33 MHz and 66 MHz. To
change the value, press the (+) key on the terminal's keypad to increment, or the (-) key to
decrement the value.
Suspend [35]
Backlt Time [10]
Cold Boot [15]
Enable [33 MHz]
Figure 8-2. Setup Screen #2
Terminal Configuration: Setup
8-5