PDT 7500 Series Product Reference Guide for DOS
1. Prepare the mounting surface to accept four #8-32 studs in the pattern shown below.
Holes for studs
Figure 3-6. Installation Pattern: VCD 7500 Vehicle Cradle
1. Install the cradle on the mounting surface.
a. Position the cradle on the mounting surface.
b. Fasten using the appropriate hardware (#8-32 screws).
2. Connect the red and black power supply input leads to a fuse panel. A qualified
installer must perform the installation.
3-8
1.188"
Note: Not to Scale
1.5"