Table of Contents
Advertisement
w i t h
Changing the Battery
Note:
Swap batteries charge when you run the terminal from
the main battery, or from an external power source. This
procedure assumes that the swap battery in your termi-
nal has enough charge to support a swap.
You can change the battery on a PPT 4300-S0E terminal without
logging out or losing your session. To do this:
1. Make sure you have a fully charged battery available and close
at hand.
2. Turn the terminal display-side down, but do not rest it on a
table. The table may cause keys to be pressed, causing input to
an application.
3. Push up on the Battery Latch, as shown. The Ejector Spring
pushes the battery up.
4. Slide the discharged battery out of the compartment. When
you remove the battery, the terminal automatically goes into
Sleep mode. A swap battery inside the terminal supplies power
and maintains your session for up to 45 seconds.
P P T
4 3 0 0
I n t e g r a t e d
18
S e r i e s
S c a n n e r
Battery Latch
Advertisement
Table of Contents
