Q u i c k
Charge the battery in the terminal for about 2 1/2 hours before
initial use.
Recharging the Battery
When battery voltage is low, a warning message appears indicating
the battery needs to be recharged. You can recharge the terminal's
battery using either the CRD 2700 Cradle or the Synchronization
Cable.
Using the Cradle to Recharge the Battery
To recharge the terminal's battery using the CRD 2700 cradle:
1. Make sure the cradle is plugged into a wall outlet.
2. Insert the PPT 2700 terminal in the cradle.
Terminal Charge LED
3. The Terminal Charge LED turns red to indicate charging, then
green when the battery is fully charged. The terminal's battery
is fully charged after approximately 2 1/2 hours.
Charging a Spare Battery
You can also recharge a terminal's spare battery by inserting it in the
spare battery charging slot in the back of the cradle, oriented so the
contacts are facing down and towards the back of the cradle. Press
the battery down into the slot until firmly seated. The battery is fully
R e f e r e n c e
5