Part Names - InFocus IN5132 User Manual

Introduction

Part names

Projector
(1) Lamp cover (108)
The lamp unit is inside.
(2) Speakers (x2) (25, 57)
(3) Filter cover (110)
The air filter and intake vent are inside.
(4) Elevator feet (x2) (28)
(5) Elevator buttons (x2) (28)
(6) Remote sensors (x2) (18, 71)
(7) Lens
(8) Lens cover
(9) Indicators (5)
(10) Intake vents
(11) Control panel (5)
(12) Status Monitor (20)
< Only for IN5142, IN5144, IN5144a and
IN5145>
(13) AC IN (AC inlet) (16)
(14) Exhaust vents
(15) Ports (5)
(16) Security bar (15)
(17) Security slot (15)
(18) Grip (below)
(19) Safety bar (15)
WARNING
directed to do so by the manuals.
►Do not subject the projector to unstable conditions.
►Do not apply shock or pressure to this product. Place
your hands on the grip on the bottom of the projector when
carrying the projector. Remove all the attachments from
the projector, including the power cord and cables, before
carrying the projector.
►Do not look into the lens or the openings on the projector while the lamp is on.
CAUTION
vents during use or just after use, since it is too hot.
►Do not attach anything onto the lens except the projector's lens cover
because it could damage or melt the lens.
(continued on next page)
4
►Do not open or remove any portion of the product, unless
►Do not touch around the lamp cover and the exhaust
(2)
(4)
(7)
(8)
(15)
(12)
(11)
(6)
(13)
(17)
(16)
(19)
(5)
(2)
(6)
(4)
(9)
(14)
(18)
(10)
Grip
(10)
(3)
(10)
(5)
(1)