Remote Control; Installing The Batteries; Using The Remote Id Function - InFocus IN5132 User Manual

Remote control

Installing the batteries

Insert batteries into the remote control before using it (batteries not included). If
the remote control starts to malfunction, try replacing the batteries. If the remote
control will not be used for a long period, remove the batteries from the remote
control and store them in a safe place.
1.
Holding the hook part of the battery
cover, remove it.
2.
Align and insert two AA batteries (HITACHI
MAXELL or HITACHI MAXELL ENERGY,
Part No.LR6 or R6P - not included)
according to their plus and minus terminals
as indicated in the remote control.
3.
Replace the battery cover in the direction of the arrow
and snap it back into place.
WARNING
Improper use may result in battery explosion, cracking or leakage, which could result
in fire, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specified. Do not use batteries of different types
simultaneously. Do not mix new and used batteries.
• Make sure the plus and minus terminals are correctly aligned when loading batteries.
• Keep batteries away from children and pets.
• Do not recharge, short circuit, solder or disassemble batteries.
• Do not place batteries fire or water. Keep batteries in a dark, cool and dry place.
• If you observe battery leakage, wipe out the leakage and then replace batteries.
If the leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing batteries.

Using the REMOTE ID function

Utilize this function to control specific projectors with the
remote control by assigning ID numbers to multiple projectors
of the same type simultaneously.
Assign an ID number to each projector before using the
REMOTE ID item in the SERVICE menu of the OPTION
menu (71). Press the ID button with the same ID number
as assigned to the projector you are going to control. The ID
button selected will light for several seconds.
NOTE
• Each time you press a button (other than an ID button), the ID button
associated with the currently selected ID number will light.
• To confirm a projector's current ID, press any ID button for 3 seconds. The
projector's ID will display on the screen regardless of which ID button is
pressed.
►Always handle batteries with care and use them only as directed.
Remote control
1
2
ID buttons
3
17