Fastening The Cables - InFocus IN5132 User Manual

Setting up
Connecting your devices (continued)
Another
projector
(Wired)
Remote
control
NOTE
• To use a wired remote control, connect a wired remote control to the
REMOTE CONTROL IN port. You can also connect another projector to the
REMOTE CONTROL OUT port to control it from the wired remote control. You
can use this projector as a remote control-relay with the REMOTE CONTROL
IN and OUT ports. To connect the wired remote control or another projector
to the REMOTE CONTROL IN or OUT ports, use audio cables with 3.5 mm
diameter stereo mini plugs. This function is useful when a wireless remote
signal cannot reliably reach the projector.

Fastening the cables

To tie the signal cables and prevent them
from coming off, fasten them to the projector
using commercially available plastic cable
ties. Use a cable tie 2.0 x 5.0mm or smaller.
We recommend curling the end of the tie
slightly before you thread it to the tie holder,
so that you can get it through easily.
WARNING
CAUTION
damage the cables and tie holder.
►Do not bind the cables too tightly. The cables or the hole may be damaged.
14
►Do not bind the power cord.
►Only use plastic ties to fasten the cables. A metal tie may
Speakers
(with an amplifier)
Monitor
(56)
Tie holder
Cable tie