Table of Contents
Advertisement
Using the remote control
The remote uses two (2) AAA batteries (not provided). They
are easily installed by removing the cover from the remote's
back, aligning the + and - ends of the batteries, sliding them into
place, and then replacing the cover.
Caution:
•
When replacing the remote batteries, be aware that using
batteries other than AAA batteries may risk severe damage
to the remote. When disposing of the batteries, be sure to
do so in an enviromentally proper manner.
•
If the remote control gets wet, wipe it dry immediately.
•
Avoid excessive heat and humidity.
•
Ensure the batteries' polarity (+/-) is aligned correctly.
•
Do not mix new and old batteries together, or mix different types of batteries
together.
•
Replace the batteries as soon as they run out.
•
Remove batteries from the remote control when storing or not in use for a
prolonged period.
To operate, point the remote at the front of the projector (not at the computer).
The range of optimum operation is about 24 feet (8m).
Press the remote's Power button to turn the projector on and off (see page 8 for
shutdown info).
Press the remote's Menu button to open the projector's menu system. Use the
arrow buttons to navigate, and the Select button to select features and adjust
values in the menus. See page 26 for more info on the menus.
Troubleshooting the remote
•
Make sure the batteries are installed in the proper orientation and are not
dead.
•
Make sure you're pointing the remote at the projector or the screen, not the
computer, and are within the remote range of 15 feet (4.5m). For best results,
point the remote at the projector.
Icon
Feature
Power on (white button): turns the projector power on.
Information: displays source information.
Help: opens help information.
Power off (red button): turns the projector power off.
Computer: toggles between the computer sources.
HDMI: toggles between the HDMI sources.
Lightcast: displays the Lightcast source.
19
Table 2:
Advertisement
Table of Contents
