Table of Contents
Advertisement
3.
POWER SUPPLY
CAUTION REGARDING THE LITHIUM-ION BATTERY PACK.
・ Do not leave the charger connected to the receiver for continuous periods in excess of
24 hours. Long term overcharging can degrade the lithium-ion battery pack and
significantly shorten its useful life.
・ A complete discharge of the battery is likely shorten its lifespan.
・ The receiver standby mode consumes some battery power even when the receiver is
switched off. If you do not use the receiver for over a month, to prevent over- discharge
of the battery, either remove the battery pack from the receiver or charge the battery
every month.
・ If you have to store the battery outside of the receiver for an extended period of time, to
prevent over-discharge you should charge it for about 2 hours once every 6 months.
・ The battery pack can be charged approximately 300 times, however over-charge or
over-discharge might reduce this number.
Do not attempt to open the battery pack as personal injury or damage to the lithium-ion cells
could occur if they become accidentally short-circuited.
3.1.
BATTERY PACK INSTALLATION & REMOVAL
INSTALLATION
1. Insert the battery in the battery compartment and press the end of the battery latch on
the bottom of the receiver.
2. Lock the pack by sliding the locking plate beside the latch until the entire "LOCK"
appears.
3. The receiver will power on automatically. To switch it off, simply press the red power
button for 3 seconds.
REMOVAL
1. Turn the receiver off.
2. Slide the locking plate until the "UNLOCK" appears entirely.
3. Lift up the end of the battery by pressing the battery latch, then pull out the battery from
the receiver.
BP-10
14
Rubber gasket must
not be loose.
Battery pack latch
Locking plate (grey color)
Slide down to unlock
Slide up to lock
Hide quick links:
Advertisement
Table of Contents
