Table of Contents
Advertisement
11-5 RESET THE AR-DV1
Resetting the AR-DV1 will return it to the original factory default settings and all memory contents will be
deleted.
There are two types of resetting; System Reset and Full Reset.
11-5-1 SYSTEM RESET
Performing System Reset will return it to the original factory default settings.
However, all search banks, search groups, memory channels, memory banks, scan groups and memory
contents will not be deleted.
To perform System Reset, perform the following steps:
1. Turn the receiver off.
2. While holding the [CLR] key, push and hold the volume knob until [Sys.Reset] is displayed on the LCD.
11-5-2 FULL RESET
Performing Full Reset will return it to the original factory default settings. All personal settings will be lost.
To perform Full Reset, perform the following steps:
1. Turn the receiver off.
2. While holding the [CLR] key, push and hold the volume and squelch knobs until [FullReset] is displayed
on the LCD.
11-6 FREQUENCY OFFSET
The frequency offset function enables receive frequency to be shifted by preprogrammed value.
This function helps quickly to track duplex transmissions or check repeater inputs/outputs.
Some offset frequencies have been preprogrammed by the factory. Frequency offset may also be
programmed manually by the user.
The locations for frequency offset storage are numbered 20 ~ 39 and cannot be changed by the user.
Locations 01 ~ 19 may be programmed by the user. To configure the frequency offset, perform the
following steps:
1. Press the [F] key and then the [ . ] (SD) key.
2. The frequency offset screen will appear.
61
Advertisement
Table of Contents
