Quick Reference Guide; Clock And Timer - AOR AR7030 Operating Manual

2-3 Quick reference guide

Key
Buttons shown white on black are labelled on the front panel, for example
Buttons shown black on grey are soft-keys labelled on the display, for example
The spin-wheel is labelled on the display and shown with up/down arrows, for example
Soft keys shown with a bullet after the legend operate as toggles (on / off). The bullet shows the current state -
solid for on and hollow for off.
Power
To turn the receiver on, press
Display
To display the S-meter, press
Filters
To change filter, press
To shift the filter passband, press
To adjust audio frequency in CW and DATA modes, press
To adjust audio tone, press
RF and IF Gain
To adjust RF gain, press
To adjust IF gain, press
OR press
Squelch
To adjust squelch level, press
OR press
OR press
With squelch active
signal is present
Memories
To select and preview a memory, press
To recall from a memory (into the VFO), press
To store into a memory (from the VFO), press
Scanning
To set scan speed, press
OR press
To scan the two VFOs, press
To scan memory channels, press
To set memory block for scanning, press
To exclude memories from scan, press

Clock and Timer

To set timer run time or sleep time, press
To set timer start time, press
To set clock time, press
To start sleep mode countdown, press
To arm timer for switch-on, press
PAGE 4 AR7030 OPERATING MANUAL
To turn the receiver off, press
To display the clock press
and use
and use
and then use
and use
and use
and use
and use
and use Sql (in NFM mode for general listening)
will mute the receiver's audio with no signal, and
and use
and then use
or Alternatively, cycle through filters with
PBS
Treb or
or for adjustment in 10dB steps
Gain (for RF and IF controls together)
Gain (for IF gain with filter bandwidth)
and use Sql (for squelch with dual VFO)
Sql (for squelch with memory scan)
and use Mxx
, use Mxx to preview then press
, use Mxx to preview then press
and use Dly (for dual VFO scanning)
Dly (for memory scanning)
then use
, use Mxx to select then press
and use Mins and
Hrs or
and then use Hrs or
Gain
or
and use BFO
Bass as required
will stop scanning if a
From
or To
Mins as required
Mins as required