Installing Mini-Slot Interface Connections - Eaton 9E Installation And Operation Manual

5. Route and install RJ-45 Controller Area Network (CAN) cables between the UPS cabinets. See Figure 4-10
and Figure 4-14 for wiring information.
6. Route and install pull chain wiring (Twisted Wires 0.5-2.0mm
MOBs. See Figure 4-10, Figure 4-13, and Figure 4-14 for wiring information.
7 . Reinstall the interface terminal cover using the retained hardware.
8. If wiring Mini-Slot connections, proceed to paragraph 4.5.3;
9. Install the power terminal cover right and left sides using the provided hardware.

4.5.3 Installing Mini-Slot Interface Connections

NOTE
LAN drop for connection to UPS communications card is to be supplied by customer.
For installation and setup of an Mini-Slot card, contact an Eaton service representative (see paragraph 1.8)
To install wiring:
1. If not already installed, install the LAN drop.
2. Route and install the LAN and other cables to the appropriate Mini-Slot cards. See Figure 4-9 and
Figure 4-10 for Mini-Slot communication bay locations.
3. Refer to the manual supplied with the Mini-Slot card for operator instructions.
4. Install the power terminal cover using the provided hardware.
Eaton 9E UPS (80-200 kVA, 380/400/415V) Installation and Operation Manual
UPS System Installation
) between the UPS cabinets and cabinet
2
4-13