System Controls; Figure 6-6. Typical Initial Setup Screen - Eaton 9E Installation And Operation Manual

Status: Status: Load Status: Status: Load Load Off Load
Load Load Off Load Load Off Off Off
Load Load Off Load Load Off Off Off
UPS UPS UPS UPS

6.2.7 System Controls

Select the CONTROLS symbol on the main menu bar, then press the RETURN pushbutton to display the
Controls screen. Normal operation, transfer to bypass, load off, and charger control commands are controlled
through this screen. In addition, the screen displays the current status of the UPS. Figure 6-7 shows the
System Control screen.
Use the or pushbutton to highlight the command screen desired, then press the RETURN pushbutton to
display the command menu screen.
Use the or pushbutton to highlight the command desired.
Table 6-4 describes the control functions and provides instructions to access and use the command menu
screens.
Table 6-5 lists the typical System Status Screen Messages that are displayed during UPS operation.
For detailed information about using the System Controls, see paragraph 6.3.
Off Off Off
Normal Normal Normal Normal
Bypass Bypass Bypass Bypass
Battery Battery Battery Battery UPM UPM UPM UPM

Figure 6-6. Typical Initial Setup Screen

Eaton 9E UPS (80-200 kVA, 380/400/415V) Installation and Operation Manual
UPS Operating Instructions
6-9