Xerox Document Centre 555 Setup Manual page 19

Select the Authentication Type your authentication server uses. The bottom portion of
the page changes to accommodate data related to your choice.
2. Enter the information in the following table that applies to the authentication type you
selected. Click Restore Settings at any time to return all settings to their previous
values.
Kerberos
(Solaris)
Kerberos
(Windows 2000)
NDS (Novell 4, 5) Enter the data you recorded for item 14 in the
SMB (Windows
NT 4 and
Windows 2000
3. When complete, click Apply New Settings.
4. When prompted, enter admin (lower case) in the User Name field. Enter 1111 or the
current password in the Password field and click OK.
NOTE: When you complete authentication set up using the Internet Services, network
authentication on the DC 555/545/535 automatically activates. Follow the procedure in the next
section to verify that authentication is set up on the DC 555/545/535, or to enable Guest
Access.
May 2004
Select IP Address or Host Name and enter the data
you recorded for item 12 in the "Installation
Information" section earlier in this document.
Select IP Address or Host Name and enter the data
you recorded for item 13 in the "Installation
Information" section earlier in this document.
"Installation Information" section earlier in this
document.
Enter the data you recorded for item 15 in the
"Installation Information" section earlier in this
document.
If the primary domain controller is located on a
different subnet than the DC 555/545/535, enter the
data you recorded for Primary Domain Controller IP
address OR Host name.
Simple Scan to Email Setup Guide Page 17