Display Troubleshooting; General Display Problems - Wacom DTK-2400 User Manual

DISPLAY TROUBLESHOOTING

If you encounter problems with the display portion of the interactive pen display, refer to the following
tables. Your problem may be described here and you can try the solution offered. For more information
about color issues, see the documentation that came with your operating system or applications.

General display problems

VGA problems
GENERAL DISPLAY PROBLEMS
No display. Power LED is off.
No display. Power LED is lit
blue.
The power LED is lit orange.
A 'no signal go to power save'
message appears briefly on
the display screen.
A 'cable disconnect go to
power save' message
appears briefly on the display
screen.
Contents Index
Verify the AC power cable is connected, and that the pen display power
switch is turned on.
Check the contrast, brightness, and backlight controls. Adjust as
necessary. Or, open the OSD menu and choose R
• Your computer may be in a power management mode.
Touch the pen tip to the display screen, move the mouse, or
depress any key on your keyboard.
• Turn off both your computer and the pen display. Check the video
cable for bent or broken connector pins. Then properly connect the
video cable and turn on the pen display and your computer.
• Verify that the video card is properly installed.
• Check that your computer is turned on.
• Verify that you are using the video cable that came with the pen
display.
• Check that the video cable is fully connected.
• Turn off both your computer and the pen display. Check the video
cable and any video adapters for bent or broken connector pins.
Then properly connect the video cable and any necessary
adapters.
Contents Index
75
.
ESET
75