Contents Index - Wacom DTK-2400 User Manual

3. Raise the display support arms to the vertical locked position. Adjust the pen display incline as needed
for adequate clearance. From the rear of the pen display, unclip and lift away the cable connector
covering.
4. Remove the screws (qty 2, Phillips) from the support arm cover which houses the cable you wish
to remove.
5. Carefully disconnect the cable and unthread it from the support arm cable track.
6. Install or replace a cable by reversing this procedure.
Contents Index
Contents Index
Screw type: Phillips, flat fillister head,
M3-17, black
Important: When installing or replacing a cable,
properly route the cable through the support arm
pivots where the arm joins the pen display and the
base of the stand. Proper routing will prevent the
cable from getting caught in the pivot mechanism.
29
29