Calibrating The Pen Display; Cintiq 24Hd - Wacom DTK-2400 User Manual

The pen selects everything or
will not stop drawing.
Double-clicking is difficult.
The eraser selects everything
or will not stop erasing.
You notice a delay at the
beginning of pen or inking
strokes.
You have to press hard with
the pen when clicking,
drawing, or writing.
The pen tip does not function.
The pen tip and screen cursor
do not properly line up.
Changing the function settings
for an input tool has no effect.
Contents Index
Open the Wacom Tablet control panel and go to the P
T F slider toward F
IP EEL
T setting. If this does not help, see
HRESHOLD
tools.
Be sure you are quickly tapping the display screen twice in the same
place. Wacom recommends using the side switch to double-click.
Open the Wacom Tablet control panel and go to the P
Try increasing the T
Set an ExpressKey to D
Windows: Try setting your system to launch programs with a single
click. See clicking.
Open the Wacom Tablet control panel and go to the E
Move the E
RASER
increase the C
controls and input
Open the Wacom Tablet control panel and go to the P
Try decreasing the T
move the T
IP
to turn off double-click assist.
Open the Wacom Tablet control panel and go to the P
Move the T
IP
the S
ENSITIVITY
Be sure you are using only the pen that came with your product,
or a Wacom accessory pen specified for use with the Cintiq 24HD.
Other pens may not function properly on the pen display.
Check the control panel P
assigned to the pen tip.
Make sure the status LED lights blue when the tip is pressed. If the
LED does not light, verify that the USB cable is plugged into an active
port on your computer or on a USB hub.
If the LED still does not light, you may have defective hardware (see
troubleshooting).
Open the Wacom Tablet control panel and select the C
Continue with
Make sure you change the settings for the tool and application that you
are using. See
tools.
Contents Index
, or select D
IRM
D C
IP OUBLE LICK
C
OUBLE LICK
F slider toward F
EEL
T setting. If this does not help, see
LICK HRESHOLD
tools.
D C
IP OUBLE LICK
D C D
OUBLE LICK ISTANCE
F slider toward S
EEL OFT
and C T
LICK HRESHOLD
tab and verify that a C
EN
calibrating the pen display.
application-specific settings
tab. Move the
EN
... and increase the C
ETAILS
testing controls and input
tab.
EN
D or using a lighter T
ISTANCE
and use it to issue double-clicks.
RASER
, or select D
IRM ETAILS
tab.
EN
D . If that does not work,
ISTANCE
slider to the O position in order
FF
tab.
EN
, or select D ... and decrease
ETAILS
settings.
function is
LICK
ALIBRATE
and working with multiple
79
LICK
F .
IP EEL
tab.
... and
testing
tab.
79