Acura 2014 TL Owner's Manual page 607

Checking and Replacing Fuses
If something electrical in your
vehicle stops working, the first thing
you should check for is a blown fuse.
Determine from the chart on pages
604 605 , and 606 , or the diagram on
the fuse box lid or the fuse label,
which fuse or fuses control that
component. Check those fuses first,
but check all the fuses before
deciding that a blown fuse is not the
cause. Replace any blown fuses and
check if the device works.
1. Turn the ignition switch to the
LOCK (0) position.
Make sure the headlights and all
other accessories are off.
: Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. VEHICLE
OFF (LOCK) Mode is the
equivalent of LOCK (0). For
more information, see pages
184 and 187 .
FUSE
BLOWN
2. Remove the cover from the fuse
box.
3. Check each of the large fuses in
the under-hood fuse box by
looking at the wire inside.
Removing these fuses requires a
Phillips-head screwdriver.
Fuses
CONTINUED
601