Acura 2014 TL Owner's Manual page 503

S Position (S) To shift into the S
position, press the release button on
the front of the shift lever, and move
the lever to S. This position is similar
to D, except only gears from first to
fifth are selected. (When shifting up
automatically, the vehicle speed is
higher than when in the D position.)
The S position keeps the
transmission from cycling between
fourth, fifth and sixth gears in stop-
and-go driving.
With the shift lever in D or S, you
can also use the paddle shifters to
shift the transmission up or down.
With the paddle shifters, you can
operate the transmission much like a
manual transmission without a
clutch pedal. For more information
on driving with the paddle shifters,
see page 501 .
Engine Speed Limiter
If you exceed the maximum speed
for the gear you are in, the engine
speed will enter into the tachometer's
red zone. If this occurs, you may feel
the engine cut in and out. This is
caused by a limiter in the engine's
computer controls. The engine will
run normally when you reduce the
rpm below the red zone.
The engine may cut in and out in R
position or depending on the road
condition, even when the engine
speed is lower than the tachometer's
red zone. This is the engine's
computer working to protect the
transmission.
Automatic Transmission
Shift Lock Release
This allows you to move the shift
lever out of Park if the normal
method of pushing on the brake
pedal and pressing the release
button does not work.
1. Set the parking brake.
2. On models without keyless access
system
Remove the key from the ignition
switch.
On models with keyless access
system
Remove the built-in key from the
keyless access remote (see page
201 ).
CONTINUED
497