AXIS 5470e/570/670e User's Manual
JES definitions
JES2 Initialization
When a TCP-attached printer is to be used with JES, it must be
defined for deferred-printing mode. To use a PSF printer for deferred
printing under JES, you must first code JES initialization statements
to define FSSs and FSAs for PSF printers. For JES2, the FSS is defined
by an FSS statement, and the FSA is defined by a PRTnnnn
statement. For JES3, the FSS is defined by an FSSDEF statement,
and the FSA is defined by a DEVICE statement.
The maximum number of FSSs and FSAs that are supported are:
•
FSSs = 2000
•
FSAs per FSS = 64
The actual number of FSAs per FSS depends on several factors like:
•
The virtual region size below the 16-megabyte line
•
The number and the size of form definitions and page definitions
•
The number of buffers specified (BUFNO) for channel-attached
printers
•
The block sizes of the font, page segment, overlay, form
definition, and page definition libraries
The example below shows a sample JES2 statements for a TCP/IP-
attached AXIS 5470e/570/670e:
FSS (FSS1) PROC=SAMPPROC,HASPFSSM=HASPFSSM
PRT1
FSS=FSS1,MODE=FSS,PRMODE=(LINE,PAGE,),
CLASS=C,UCS=0,SEP=NO,SEPDS=NO,CKPTPAGE=100
START=YES,MARK=NO,TRKCELL=YES
Note:
This is only an example. For specific coding for JES parameters, refer to the JES
publication for the level of JES you are using.
Section 5: Setting Up - IBM Mainframe
95