Axis 5470e User Manual page 53

AXIS 5470e/570/670e User's Manual
Verifying the
Communication Link
4. Click the Add Session button. This will start the Configuration
Wizard which is a step-by-step guide through the required IBM
configuration settings.
1. Type WRKCFGSTS *CTL xxxx* on the AS/400 command
line (xxxx is the first four characters of the AXIS
5470e/570/670e 5494 LU Name) and press Enter. After a
couple of minutes, ensure that the following items are displayed:
• One APPC controller with the same name as the AXIS
5470e/570/670e 5494 LU Name .
• One APPC device with the same name as the AXIS
5470e/570/670e 5494 LU Name , one controller session
(QRMTWSC) and the currently active printer sessions
(QRMTWSC) .
• One twinax controller named xxxxxRMT , where xxxxx are
the first five characters of the AXIS 5470e/570/670e 5494
LU Name .
• One, two or three twinax printer devices named
xxxxPRT0z ( xxxx are the first four characters of the AXIS
5470e/570/670e 5494 LU Name and z is the printer
device number).
The status of all items should now be ACTIVE or VARIED ON .
2. Type STRPRTWTR xxxxPRT0z on the AS/400 command line
(xxxxPRT0z is the printer device name) and press Enter. This
command starts the writer for this printer device.
3. Press the AXIS 5470e/570/670e test button once to print a test
page. Ensure that the SNA status is defined on the test page as
Idle, Actv or LU-4 .
Section 4: Setting Up - AS/400
53