Axis 5470e User Manual page 41

AXIS 5470e/570/670e User's Manual
AXIS 670e
Token Ring
Print Servers:
Using BOOTP
in UNIX
1. Append the following line to your Ethernet Address table. This is
typically located in the
<Node address> <host name>
Example:
00:02:31:48:00:61 npsname
2. Update, if necessary, your host table and alias name databases, as
required by your system.
3. If it is not already running, start the RARP daemon. This is
typically performed using the
4. Restart the AXIS 670e to download the IP address.
Notes:
• The Node address
on the underside label of the AXIS 670e.
• If you are a IBM AIX user, you will probably not have access to a RARP
daemon. If this is the case, you can use either the ARP or BOOTP methods
instead.
Follow the instructions below to set the IP address using BOOTP:
1. Append the following entry to your boot table. This is typically
performed by editing the file:
<host name>:ht=<hardware type>:vm=<vendor magic>:\
:ha=<hardware address>:ip=<IP address>:\
:sm=<subnet mask>:gw=<gateway field>
Example - AXIS 5470e/570 Ethernet Print Servers:
npsname:ht=ether:vm=rfc1048:\
:ha=00408c100086:ip=192.168.3.191:\
:sm=255.255.255.0:gw=192.168.1.1
Section 3: Basic Installation
file:
/etc/ethers
command.
rarpd -a
is equal to the serial number, which can be found
/etc/bootptab
41