Axis 5470e User Manual page 35

AXIS 5470e/570/670e User's Manual
Using AXIS IP
Installer
Using DHCP
Follow the instructions below to set the IP address of your AXIS
5470e/570/670e using the AXIS IP Installer:
Note:
You should not use AXIS IP Installer to set the IP adress if you have an active
DHCP server on your network.
1. Download the AXIS IP Installer to your host. The software is
available on the AXIS Product CD or on the Axis home page at
http://www.axis.com/.
2. Connect the AXIS 5470e/570/670e to the network. Note the
serial number that is located on the underside label of the AXIS
5470e/570/670e. You will need it in the proceeding steps.
3. Start the AXIS IP Installer.
4. Click the serial number of your AXIS 5470e/570/670e that
appears in the server list.
5. Enter the desired IP address in the designated IP address field and
click the Set IP address button.
6. The IP setting process will take approximately 10 to 40 seconds.
Click OK in the confirmation box that appears when the IP
address has been set.
Notes:
• AXIS IP Installer uses the BOOTP and DHCP protocols to communicate
with the AXIS 5470e/570/670e. Make sure that at least one of these
protocols is enabled in your print server.
• Restart your AXIS 5470e/570/670e, if it does not show up in the server list.
Follow the instructions below to download the IP address using
DHCP:
1. Edit or create a scope in the DHCP manager of the DHCP
daemon. The entries included in this scope should contain the
following parameters:
Section 3: Basic Installation
35