Axis 5470e User Manual page 40

Section 3: Basic Installation
40
Using RARP in UNIX
AXIS 5470e/570
Ethernet Print Servers:
Notes:
• The node address
on the underside label of the AXIS 670e.
• The ARP command varies between different UNIX systems. Some BSD type
systems expect the host name and node address in reverse order.
• When you execute the ping command for the first time, you may experience
a significantly longer response time tha
Follow the instructions below to set the IP address using RARP.
1. Append the following line to your Ethernet Address table. This is
typically located in the
<Ethernet address> <host name>
Example:
00:40:8c:10:00:86 npsname
2. Update, if necessary, your host table and alias name databases, as
required by your system.
3. If it is not already running, start the RARP daemon. This is
typically performed using the
4. Restart the AXIS 5470e/570 to download the IP address.
Notes:
• The Ethernet address
found on the underside label of the AXIS 5470e/570.
• If you are a IBM AIX user, you will probably not have access to a RARP
daemon. If this is the case, you can use either the ARP or BOOTP methods
instead.
AXIS 5470e/570/670e User's Manual
is equal to the serial number, which can be found
n usual.
file:
/etc/ethers
command.
rarpd -a
is equal to the serial number, which can be