Axis 5470e User Manual page 248

Appendix C: Extended IBM Printer Emulation AXIS 5470e/570/670e User's Manual
248
• width is the bar code module width in 1/1000 inch. Valid range is
1 to 1000. The default value is 12.
• height is the bar code element height in 1/24 inch. Valid range is
1 to 500. The default value is 12.
• text mode selects if human readable text is printed under the bar
code or not. 'YES' or 'ON' will turn on text, 'NO' or 'OFF' will
turn off text. The default mode is 'ON'.
• check mode selects if a check digit will be generated or not. 'YES'
or 'ON' will generate a check digit, 'NO' or 'OFF' will not gener-
ate a check digit. The default mode is 'ON'. The check digit will
always be generated for bar code types UPCA, EAN8 and
EAN13, regardless of the setting of check mode.
To set up the BAR parameter, use the
document. To print bar codes, bar code commands may be included
anywhere in your documents. They begin with 'percent-slash' (
followed by the word BAR. Then follows the number of the bar code
definition to be used, a comma, and the sequence to be printed. The
command is ended by a semi-colon (;).
Example 1:
Setting up the bar code parameters and printing bar codes .
%CONFIG+
BAR 0 = EAN8,12,4,ON;
BAR 1 = EAN8,12,8,ON;
SAVE;
%CONFIG-
%/BAR 0,"0123456"; %/BAR 1,"0123456";
Example 2:
Once the BAR parameter has been set up, you will only need to use
the bar code commands to print the bar codes.
%/BAR 0,"0123456";
command in your
%CONFIG
%/BAR 1,"0123456";
)
%/