Figure 8: Scb; Table 20: Parts List For A Fully Configured Router; Table 21: Accessory Box Parts List - Juniper MX240 Hardware Manual

If any part is missing, contact a customer service representative.
A fully configured router contains the router chassis with installed components, listed
in Table 20 on page 39, and an accessory box, which contains the parts listed in
Table 21 on page 39. The parts shipped with your router can vary depending on the
configuration you ordered.

Table 20: Parts List for a Fully Configured Router

Component
Chassis, including midplane, craft interface, and
rack-mounting brackets
DPCs
Routing Engines
SCBs
DC power supplies
AC power supplies (220 V)
AC power supplies (110 V)
Fan tray
Air filter
Air filter tray
Quick start installation instructions
Mounting shelf
Blank panels for slots without components installed

Table 21: Accessory Box Parts List

Part
Screws to mount chassis and small shelf
DC power terminal Lugs, 6-AWG
RJ-45-to-DB-9 serial cable to connect the router through
the serial port
Cable manager brackets
Terminal block plug, 3–pole, 5.08 mm spacing, 12A, to
connect the router alarms
Chapter 5: Unpacking the Router
Quantity
1
Up to 3
1 or 2
1 or 2
1 or 2
1 or 2
2 or 4
1
1
1
1
1
One blank panel for each slot not
occupied by a component
Quantity
22
5
1
2
2
Verifying Parts Received
39