Table of Contents
Advertisement
Table 5-1. Some Error Conditions in Operation of 4600 Series IP Telephones—Continued
Condition
The telephone had been
working, but does not
work now,
AND no lights are lit on
the phone and the
display is not lit.
AND power to the
telephone is fine, but
there is no dialtone.
(Display might show
"System Busy".)
AND the telephone was
recently moved.
AND the network was
recently changed
(servers upgraded or
replaced, your Avaya
media server switches,
etc.).
Troubleshooting Guidelines
Cause/Resolution
CAUSE: Loss of power.
RESOLUTION: Check the connections
between the telephone, the power
supply, and the power jack.
CAUSE: Loss of communication with the
PBX switch
RESOLUTION: Check LAN continuity
from the PBX to the telephone (using
ping or trace-route) and from the
telephone to the PBX (by invoking a
feature button). Verify the LAN
administration has not changed for the
TN799 or TN 2302AP boards or the LAN
equipment (routers, servers, etc.)
between the switch and the telephone.
Verify no one has locally changed the
telephone settings (by using the VIEW
and ADDR codes, as described in the
4600 Series IP Telephone Installation
Guide). Verify the volume on the
telephone is set high enough. Finally,
conduct a self-test.
CAUSE: Loss of communication with the
PBX.
RESOLUTION: As above, but pay
particular attention to the possibility that
the telephone is being routed to a
different DHCP server, or even a
different PBX switch. If so, the new
server or switch may need to be
administered to support the telephone.
CAUSE: Loss of communication with the
PBX.
RESOLUTION: As above.
Error Conditions
5-3
Advertisement
Table of Contents
