Table of Contents
Advertisement
4600 Series IP Telephone LAN Administrator's Guide
TFTP Generic Setup
The following phases are involved in setting up a TFTP server.
Install the TFTP server software. The section below describes how to install and configure
Avaya's TFTP application.
Configure the file path parameter to the directory where the files are to be stored. This is the
file path in line
you disable the ability to upload to the server. Note that this option may be not available to all
TFTP servers.
You may also enable the transfer size option (tsize) if your TFTP server supports it. Doing so
allows the IP telephone to monitor the transfer's progress by displaying the total number of
data blocks.
Download the upgrade script file and application file from the Avaya website
www.avaya.com/support) to the directory as specified by the file path.
Avaya TFTP (Suite Pro)
Configuration
Use the following procedure to configure the Avaya TFTP server.
1. Run the TFTP Suite Pro server by selecting
→
Start
Programs
The TFTP server starts.
WARNING:
You must re-start Avaya TFTP manually every time you reboot your TFTP server
machine.
2. Select System
3. Enter the following values:
On the Outbound tab page: 1.
The Outbound path is the TFTP file path as recorded in
Network Information Before Installation - Per DHCP
The Enable Path options should be checked.
Under the Options tab page: turn on the No Incoming option.
Under the Client Limits tab page: Drag the slide bar all the way to the right to set the
Maximum Simultaneous Clients to infinite.
4. Place the 46xxupgrade.scr file in the file path directory. (The filename 46xxupgrade.scr is an
example, not the filename you will use. See
TFTP
4-18
6
of
Table 4-2, on page
→
Avaya TFTP Server
→
Setup.
4
4-6. For increased security, it is also recommended that
4
→
TFTPServer32.
Table 4-2, on page
Server.
Contents of the Upgrade Script, on page
(http://
4
4-6,
Required
4-21.)
Advertisement
Table of Contents
