Table of Contents
Advertisement
4600 Series IP Telephone LAN Administrator's Guide
Windows 2000
DHCP Server
®
This section describes the configuration of the DHCP server in Windows 2000
Verifying the Installation of the DHCP Server
Use the following procedure to verify whether the DHCP server is installed.
→
1. Select Start
2. Under Services and Applications in the Computer Management tree, you should find DHCP.
3. If DHCP is not installed, install the DHCP server; otherwise proceed directly to
Configuring a DHCP Scope, on page 4-14
Creating and Configuring a DHCP Scope
Use the following procedure to create and configure a DHCP scope.
→
1. Select Start
2. In the console tree, click the DHCP server to which you wish to add the DHCP scope for the IP
telephones. Typically this will simply be the name of your DHCP server machine.
3. Select Action
Windows displays the New Scope Wizard to guide you through rest of the setup.
4. Click the Next button.
The Scope Name dialog box displays.
5. In the Name field, enter a name for the scope such as "DEFINITY IP Telephones," then enter
a brief comment in the Description field.
6. When finished, click the Next button.
The IP Address Range dialog box displays.
7. Define the range of IP addresses used by the IP telephones listed in item
page
4-6· The Start IP Address should be the first IP address available to the IP telephones.
The End IP Address should be the last IP address available to the IP telephones.
We recommend not mixing 4600 Series IP Telephones and PCs in the same scope.
8. Define the subnet mask in one of two ways:
The number of bits of an IP address to use for the network/subnet IDs.
The subnet mask IP address.
Enter only one of these values and when finished, click the Next button.
The Add Exclusions dialog box displays.
DHCP
4-14
→
Program
Administrative Tools
→
Programs
Administrative Tools
→
New Scope from the menu.
4
4
→
Computer Management.
for instructions on server configuration.
4
→
DHCP.
®
.
Creating and
7
in
Table 4-2, on
Advertisement
Table of Contents
