Omron E5CN User Manual page 84

Adjustment Level
sp-0
Set point 0
sp-1
Set point 1
sp-2
Set point 2
sp-3
Set point 3
Function
Setting
See
74
These parameters set the set points when the multi-SP function is used.
The values set in these parameters can be selected by operating the keys on
the front panel or by event input.
• When the set point has been changed, the set value of these parameters
currently set by multi-SP is linked and changed.
• During temperature input, the decimal point position is dependent on the
selected sensor.
During analog input, the decimal point position is dependent on the setting of
the "decimal point position" parameter.
Setting Range
Set point lower limit to set point upper limit
Related parameters
"Number of multi-SP uses" (advanced function setting level)
"PV/SP" (operation level) "Input type" (initial setting level)
"Input type" (initial setting level)
"Event input assignment 1" (advanced function setting level)
"Event input assignment 2" (advanced function setting level)
"Multi-SP uses" (advanced function setting level)
Section 5-4
The "number of multi-SP uses"
parameter must be set to either "1" or
"2", and the "multi-SP uses" parame-
ter must be set to "ON".
Unit
EU 0
Default