Omron E5CN User Manual page 78

Operation Level
Run/Stop
Function
See
Alarm value 1
Alarm value 2
Function
Setting
See
68
This parameter specifies run and stop.
When "run: run" is selected, control is running. When "stop: stop" is selected,
control is stopped. When control is stopped, the STOP display lights.
Default is "run".
When the run/stop function is being controlled by event input, the run/stop
function cannot be set by operating the keys on the front panel.
This parameter sets the input value "X" in the alarm type list.
• This parameter is used for setting the alarm values of alarm outputs 1 to
2.
• During temperature input, the decimal point position is dependent on the
currently selected sensor, and during analog input it is dependent on the
"decimal point" parameter setting.
Setting Range
-1999 to 9999
The alarm type must be set to other than upper and lower limit alarm.
Related parameters
"Input type" "Scaling upper limit" "Scaling lower limit" "Decimal point"
"Alarm 1 type" "Alarm 2 type" (initial setting level)
"Alarm 1 open in alarm" "Alarm 2 open in alarm" "Alarm 1 hysteresis" "Alarm 2
hysteresis" "Standby sequence reset method", "Alarm 1 to 2 latch" (advanced
function setting level)
The run/stop function must not be set
to event input assignments 1 and 2.
The alarm type must be set to other
than upper and lower limit alarm.
The control must be set to standard
control. (Alarm value 1 only)
Unit Default
EU 0
Section 5-3