Sony MSW-900 Operation Manual page 70

2
Set the POWER switch to ON. Check that the HUMID indicator
does not appear and that the BATT indicator shows at least five
segments.
• If HUMID indicator appears, wait until it disappears.
Note
After turning off the power, check whether the drum is dry (even
if the HUMID indicator is off) when the turning on the power
again.
• If the BATT indicator does not show at least five segments,
replace the battery pack with a fully charged one.
3
Check that there are no obstructions near the cassette lid. Then
press the EJECT button to open the cassette lid.
4
After checking the points below, load the cassette and close the
cassette lid.
• The cassette is not write-protected.
• There is no slack in the tape.
Chapter 3 Recording and Playback
3
3-7