Sony MSW-900 Operation Manual page 41

wa VIDEO OUT (video output) connector (BNC type)
This connector outputs a composite video signal (standard level, 75-ohm
terminated) to the video monitor. If the video monitor is connected here,
2
you can monitor the picture being shot by the camcorder as well as the
picture recorded by the VTR. When synchronizing the time code of an
external VTR with that of the camcorder, connect this connector to the
GENLOCK IN connector of the external VTR.
By attaching the MSDW-902 extension board (not supplied), you can
output an SDI signal (corresponding to EDH) from the VIDEO OUT
connector. Select composite video signal output or SDI signal output
through the menu.
For detailed information on how to select the output signal, see "4-8-2 Selecting
the Output Signals" on page 4-100.
ws REMOTE (remote control) connector (8-pin)
Connect the RM-B150 Remote Control Unit (not supplied), which makes
VTR and camera control possible.
wd TEST OUT (test output) connector (BNC type)
This connector outputs the video signal (standard level, 75-ohm
terminated) for the video monitor. The output signal can be selected to
be a composite, R, G, or B. The factory setting is composite, and the
setting returns to composite whenever the power is switched on.
Depending on the internal board and menu settings, the menu, the time
code and the shot data can be displayed over the image on the monitor.
As for the VIDEO OUT connector, you can use this connector for
synchronizing the time code of an external VTR with the time code of
the camcorder.
For detailed information on how to select the test output signal, see the
Maintenance Manual (not supplied).
2-25
Chapter 2 Locations and Functions of Parts and Controls