Sony MSW-900 Operation Manual page 227

Item
REAR BNC OUT SEL Selects the type of the video signal to be
a) When the MSDW-902 (not supplied) is not installed, this
selection is not effective.
3
Turn the MENU knob to move the t mark to REAR BNC OUT
SEL, and push the MENU knob.
The t mark to the left of REAR BNC OUT SEL changes to the z
mark and the z mark to the left of the setting changes to the ? mark.
4
Turn the MENU knob to change the desired setting, and push the
MENU knob.
The z mark to the left of the selected item changes to the t mark
and the ? mark to the left of the setting changes to the z mark.
5
To end menu operations, set the MENU ON/OFF switch to OFF.
Content
output from the VIDEO OUT connector.
SDI a) : Outputs the SDI signal. When SDI is
selected, connect the VIDEO OUT
connector to the SDI IN connector of the
video monitor.
VBS: Outputs the analog composite video
signal. When VBS is selected, connector the
VIDEO OUT connector to the VIDEO IN
connector of the video monitor.
OFF: This allows you to save the power.
Chapter 4 Adjustments and Settings for Recording
4
4-101