Sony MSW-900 Operation Manual page 159

Input level of audio channels CH-3 and CH-4
The levels of the audio signals recorded in audio channels CH-3 and CH-
4 are automatically adjusted. You cannot adjust them manually.
You can select the audio signal to be recorded in audio channels CH-3
and CH-4 using the AUDIO IN CH-3/CH-4 switches.
Notes
• The AUDIO IN CH-3/CH-4 switches are not activated when you use
the camcorder for the first time after purchase because the camcorder
has been set at the factory so that the input signals to be recorded on
audio channels 3 and 4 are the same as the ones input to the AUDIO IN
CH-1/CH-2 connectors.
To activate this switch, change the setting of the AUDIO CH3/4
MODE item from CH1/2 to SW on the VTR MODE 1 page of the
MAINTENANCE menu.
• The XLR connector automatic detection function does not affect audio
signals recorded on audio channels CH-3 and CH-4.
The audio signal from the front microphone
connected to the MIC IN connector is recorded.
The audio signal input to AUDIO IN CH-1
The audio signal of the wireless microphone
The audio signal from the front microphone
connected to the MIC IN connector is recorded.
The audio signal input to AUDIO IN CH-2
The audio signal of the wireless microphone
Audio signals to be recorded in audio channels CH-3 and CH-4
connector is recorded.
is recorded.
connector is recorded.
is recorded.
Chapter 4 Adjustments and Settings for Recording
CH-3
F
R
W
CH-4
F
R
W
4-33
4